Welcome back everybody! Be sure to subscribe! Today we are continuing our MRROne Project Railroad, a great compact beginner model railroad for everyone!. We are installing the foam base terrain today and painting it. The big thing we are doing though is laying the track and wiring up the DCC System. We will be using DCC++ for this layout. I have linked all of the necessary tutorials to program the DCC++ system below
DCC++ Base Station
Raspberry Pi Setup (Non Disk Image Version)
JRMI Setup
Engine Driver Setup
Track Plan
Track Needed
9.75 in Curves – (Need 8 pieces)
12.85mm Curve (15 degree) – (Need 1 piece)
Turnouts
#6 Left – (Need 2 pieces)
#6 Right – (Need 2 pieces)
Straights
248mm – (Need 8 pieces)
186mm – (Need 2 pieces)
62mm – (Need 4 pieces)
Unijoiners – (Need 6 pieces)
3D Rendering of board
Timestamps
00: 00 Introduction
00: 55 Foam Terrain and Paint
03: 12 Track Installation
06: 40 DCC Wiring
08: 12 DCC++ and JMRI
13: 00 Test Run
14: 00 Conclusion
Supplies
Arduino UNO
L298N Motorshield
Raspberry Pi Kit
12V power supply
DC Plug terminals
Power Bus
Power Strip
Tools
Electric Drill (This is the one I use)
Drill Bit set with Spade Bits
Caulking Gun
Follow us on Facebook
You can support the channel by becoming a Patron on Patreon for as little at $1 a month!
Check out my Etsy Store!
I do a lot of 3D printing
Printers Used
Elegoo Mars
Anycubic Mega Zero
Samaritan’s Purse
Camera Used
Support the channel with some Merchandise!
Connect with me at ddrrcommunity@gmail.com
“The godly may trip seven times, but they will get up again.
But one disaster is enough to overthrow the wicked.
Don’t rejoice when your enemies fall;
don’t be happy when they stumble.
For the Lord will be displeased with you
and will turn his anger away from them.
Don’t fret because of evildoers;
don’t envy the wicked.”
Proverbs 24: 16-19 NLT